How to Make Car Wash Shampoo at Home

Introduction

Car wash shampoo is a special type of liquid soap used specifically for washing cars. It is formulated to be gentle on the car’s exterior while still effectively removing dirt, grime, and other debris. While there are many commercial car shampoos available on the market, it is possible to make your own car wash shampoo at home.

Making your own car wash shampoo at home is an economical and environmentally friendly alternative. You can customize the recipe to suit your needs, using natural ingredients that are both safe for your car and better for the environment.

Gather Ingredients

The basic ingredients for making your own car wash shampoo at home include liquid soap, baking soda, and water. Liquid soap can be any kind of detergent or dishwashing liquid. Baking soda is a mild abrasive that helps remove stuck-on dirt and debris. Water will be used to dilute the ingredients and create the shampoo solution.

You will also need measuring cups and spoons, a large bowl, and a stirring utensil. All of these ingredients and materials can usually be found in most grocery stores, hardware stores, and home improvement stores.

Prepare Solution

Once you have all the necessary ingredients and materials gathered, it’s time to mix the car wash shampoo. Begin by pouring 2 cups of liquid soap into the bowl. Add 1 cup of baking soda and stir until the two ingredients are completely combined. Then slowly add 2 gallons of warm water, stirring as you go. Continue stirring until the mixture is completely blended and the consistency is smooth.

The resulting solution should be thick but not too thick, and slightly foamy. If the mixture is too thick, add a little more water until it reaches the desired consistency. Once the shampoo is ready, transfer it to a large bucket or container for easy storage.

Apply to Car

When it’s time to wash your car, begin by wetting the surface with clean water from a hose or bucket. This will help the shampoo stick to the car and reduce the risk of scratching. Then take the bucket of car wash shampoo and pour some onto a sponge or cloth. Gently rub the shampoo over the car’s exterior, starting from the top and working your way down.

Be sure to work in small sections, rinsing off the soapy residue as you go. When finished, use a microfiber cloth to wipe away any remaining residue. Be sure to avoid scrubbing too hard, as this can cause scratches and damage to the car’s exterior.

Rinse

Once you’ve finished applying the car wash shampoo, it’s important to rinse off the car with clean water. This will help remove any remaining soapy residue, as well as any dirt or debris that was loosened during the washing process. A hose or bucket of clean water should be used to rinse the car from top to bottom.

Be sure to pay close attention to any seams, crevices, or other hard-to-reach areas. These areas tend to collect dirt and grime, and may require some extra scrubbing or brushing to get them clean.

Dry

Once you’ve finished rinsing the car, it’s time to dry it off. The best material for drying a car’s surface is a clean, absorbent cloth such as a microfiber towel. Start at the top of the car and work your way down, gently wiping away any excess water. You can also use a squeegee to remove any standing water from the surface.

Be sure to avoid rubbing or scrubbing too hard, as this can cause scratches and damage to the car’s exterior. Once you’ve finished drying the car, allow it to air dry for a few minutes before driving away.

Conclusion

Making your own car wash shampoo at home is a simple and economical way to keep your car looking its best. By following the steps outlined above, you can easily create a safe and effective shampoo solution that is perfect for cleaning and maintaining your car’s exterior.

Remember, it’s important to always use a gentle touch when cleaning and maintaining your car, as rough scrubbing or rubbing can cause scratches and damage to the paint. With regular care and maintenance, your car will stay looking like new for years to come.